Automatic Press Bottom Dead Point Monitoring Device
> RM-2305(RB/RX)
> RM-2402(BX)
> RM-2404(BX)
> RM-1310(V)
Bottom Dead Center Reference Value Monitoring Device
> RM-7302 , RM-7304(VX)
> RM-7201(GX)
Dynamic Displacement Acquisition System
> RM-3000(Ⅲ)
Miss Detection Unit
> RM-2703(BM)
Press Load Monitoring Device
> RM-7402 , RM-7404(VL)
Header Former Monitoring Unit
> RM-2803 , RM-2804(77)
Type of sensors
> RS-833H et al.
SG Spray System
> SG-K4
> catalog

We provide a trusted brand for customers.

Provide the reliable brand to customers JAB ISO9001

Miss Detection Unit

  Miss Detection Unit NEW SELBER BM
  RM-2703(BM) detects disconnection of ray material, jamming of raw material and discharge of stamped parts in automatic production of press stamping line and it contributes to avoid production of defective products in advance. RM-2703
  Product Introduction movie  
for Windows
Media Player
Reg Quality High Quality
for Macintosh
Quick Time
Reg Quality High Quality

Windows Media Player or QuickTime must be installed to view the movie. Click the banner to download the plugin. Get WindowsMediaPlayer

Get Quick Time
  • It will allow for compact combination with our Slug Detector BX (RM-2402).
  • The brightness of display is about 4 times brighter than conventional unit. It keeps clear view from a distance.
  • It is miniaturized in a half size of the conventional unit (MB + MX).
  • Low speed timing filter circuit is equipped to cope with timing sinals from switches.
  • This unit can correspond to 2500 spm high speed press machine.
  • DC12V power source for sensor use is equipped as standard item.
  • 3channels to detect disconnection / jamming of raw material and 2 channels to detect synchronization / memory.
    (7 channels are available as maximum by using 2 channels of synchronization / memory to detect disconnection / jamming of raw material.)
  • Input signal can be taken from contact point and PNP / NPN transistor open collector output.
To details
  Download of the manual (PDF file) is available.
*Select "Right click=Save the object into file" to save the data in a file.